IQSB_GSM_TH
IQboard

IQSB_GSM_TH

2G GSM gate opener and controller board with two latching relays, SMS alarms and temperature/humidity sensing.

Phase Out
ProducerIQtronic technologies Europe s.r.o.
Production Started
2012
Planned Until
2016
Overview

IQSB_GSM_TH — 2G GSM gate opener and controller board with two latching relays, SMS alarms and temperature/humidity sensing.

IQSB_GSM_TH 2G GSM gate opener (GSM key) and GSM gate controller: call, SMS and DTMF access, two latching relays, low standby power, pump control and remote restart.

IQSB_GSM_TH is a 2G GSM controller board for integration into equipment. Two independent latching relay outputs switch connected loads by SMS, phone call, DTMF or on-board buttons. Built-in temperature and relative humidity sensors and two optically isolated digital inputs support remote monitoring and alarm messages. The scheduler supports up to 20 actions and can obtain the time from the GSM network when supported by the operator. Seven resettable counters, alarms for input state, temperature, humidity, supply-voltage drop and GSM base-station changes, and a microphone support remote monitoring. DTMF keypad control is protected by a PIN. Each relay is rated up to 16 A at 230 V AC for resistive loads; use a suitable external contactor for other loads. The original ordering designation was IQSB-GSM900-TH.

Originally designed as a GSM gate opener (GSM key) for gates and access control, IQSB_GSM_TH could switch its outputs by phone call, SMS or PIN-protected DTMF. Its latching relays kept standby power consumption low. The same board was also used for remote equipment restarts as a watchdog, pump control and other monitoring tasks. For suitable loads and installations, use an external contactor where required.

Applications

Real-world use cases

GSM gate opener
Open a gate or control access remotely by authorised phone call, SMS or PIN-protected DTMF.
Remote equipment restart
Use a relay output to restart installed equipment remotely when a watchdog or maintenance action is needed.
Pump control
Switch a suitable pump circuit through an external contactor and monitor the installation with the board's inputs and alarms.
Low-power installations
Latching relays reduce standby demand in installations that use a battery or backup power supply.
Technical Specifications

Specifications

Full electrical and mechanical data is available in the datasheet.

Network2G GSM, quad-band 850/900/1800/1900 MHz
Relay outputs2 × bistable changeover relay, 230 V AC / 16 A maximum for resistive loads
Digital inputs2 × optically isolated, up to 30 V DC
SensorsBuilt-in temperature and relative humidity sensors
ControlSMS, phone call, DTMF and on-board buttons
Power supply8–24 V DC or 6–16 V AC
Dimensions100 × 70 × 30 mm
Documents & software

Documents & software

Everything you need for installation, configuration and operation.

Documents

Documentation & downloads

Datasheets, manuals and firmware, all in one place? Go to: Download center →